Ava Replacement Band Installation

Installation Information:

Take care assembling your Ava tracker!

I recommend a clean work space, set of tweezers for the screws, and a #000 Phillips screwdriver (Included).

Use a #000 Phillips screwdriver (Included) to remove the two screws on the underside of the Ava tracker. Don't lose the tiny screws!!
Separate the Ava tracker from the original Ava band.
Orient the Ava tracker above the Adapter and align the tabs where the screw holes are, with the notches in the adapter.
Press the Ava Tracker into the adapter. It is a snug fit, it is best to seat one tab into the notch first, then push the adapter to fit over the second tab.
Position the screws into the clearance holes of the replacement adapter and tighten. Careful not to over-tighten! As tight as two fingers on the screwdriver can get.

*Note* The clearance holes quite small since the screw heads are tiny. If the holes are insufficient, run a screw through the hole prior to assembly.

Watch bands that are shipped with the adapter are quick latch connections.

Orient the textured side of the watch band, down.
Insert the pin opposite the quick latch into one of the adapter band connections.
Pull back on the watch band quick latch, the visible pin on the side of the band will retract into the band.
Slide the band so the second pin lines up with the adapter hole.
Release the pin and check for a secure connection.

If you have any issues, please feel free to contact us at AvaReplacementBand@gmail.com